Tl-audio 5001 Bedienungsanleitung

user manualTL Audio®Ivory 2 Series5001QUAD VALVE PREAMPTL Audio Ltd, Letchworth, Herts, SG6 1AN, UKemail: [email protected] web: http://www.tlaudio

gain is increased, over the range 0dB to +12dB: this should be accompanied by a ‘thickening’ and ‘warming’ of the audio signal, as more harmonic dis

eliminates the need for an external DI (Direct Injection) box since the high impedance instrument input will convert the signal to a high quality ba

FUSE T1AL 250V230V~25VA 115V~25VAManufactured by TL Audio Limited, England. 5001 QUAD VALVE PREAMP SERIAL NUMBERJACK: TIP = +VE, SLEEVE = GND.

5. GETTING STARTED 1. Having powered up the 5001 and ensured all the gain controls are at minimum, connect its line output to the desired

unless you are using multiple mics through the 5001 and some phase cancellation is occurring. 7. Try backing off the input gain and then stea

Crosstalk: Better than -70dB at 10KHz. (Mic inputs). Drive LED: Increasing intensity to reflect valve drive, commencing at

Should the 5001 require service, it must be taken or posted to an authorised dealer. Please retain the original packing for possible future use, and

CONTENTS 1 INTRODUCTION 2 PRECAUTIONS 3 INSTALLATION 3.1 AC Mains Supply 3.2 Audio Operating Level 3.3 Microphone Inputs 3.4 Instrument Inpu

1. INTRODUCTION Congratulations on purchasing the Ivory 5001 Quad Valve Preamp by TL Audio! The T L Audio Ivory 2 Series consists of a range o

Finally, the optional DO-4 digital output card may be fitted which provides high quality A-D conversion of each channel output. The digital output

3. INSTALLATION 3.1 AC Mains Supply. The unit is fitted with an internationally approved 3 pin IEC connector. A mating socket wi

unbalanced jack connectors are generally intended for interfacing to semi-professional equipment and have an operating level of -10dBu, or about 225

- Pin 3 = Signal Non-Phase (“-” or “cold”). 3.6 Unbalanced Outputs. An unbalanced line output is provided for each channel, on a 0.25” mono ja

The 4 XLR mic inputs are at the rear of the 5001. Virtually any low impedance professional microphone can be used. Condenser microphones will requir